Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Yaesu VR-5000
#1
I use a Yaesu VR-5000. The device does not respond to the control program. I have tried several settings without success. What can I do to?
Thank you!
Reply
#2
dg4dsl Wrote:I use a Yaesu VR-5000. The device does not respond to the control program. I have tried several settings without success. What can I do to?
Thank you!

Hi,
Can you make sure your VR-5000 is set up at 38400 bauds, 8N1,
and NO hardware handshake (no CTS/RTS) ?
73 de Mauro, IZ2BKT
Reply
#3
Does not work anyway. I have tried all possible settings.
Reply
#4
Sorry, this program uses HamLib to communicate with the rtx, try to see the HamLib forum http://sourceforge.net/projects/hamlib/f...orum/25919
73 de Mauro, IZ2BKT
Reply
#5
Thanks for the reply. I also use fldigi that works well with hamlib. There, the control works without problems.
Reply
#6
Please, how you've set fldigi? Thanks.
73 de Mauro, IZ2BKT
Reply
#7
I use standard settings of hamlib, set of fldigi.

Use Hamlib
Retries 0
Write Delay 70
Retry Intervall 1000
Post write delay 210
Baud rate 4800
Stopbits 2
Sideband Rig mode
Reply
#8
From the Alpha 20 version I've added new settings in the "COM setting", if you want to do some testing. Thanks.
73 de Mauro, IZ2BKT
Reply
#9
Thank you! It does not work with the new version. Do I need to change the "CI-V address" something? The entry is 0.
Reply
#10
The CI-V address is only used with the RTX Icom.
73 de Mauro, IZ2BKT
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)