Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Quickset
#1
When using quickset if I click on one of the buttons for a local repeater the frequency and everything changes correctly but after approximately 2 seconds the S meter on the rig and the software show a full reading and there is a loud hissing from the Icom IC7000 just fractionally turning the Volume up or down on the Rig rectifies the problem
Reply
#2
Please, send me as MP the file quickset.dat
73 de Mauro, IZ2BKT
Reply
#3
I did not receive the attachment, please try again. Thank You.
73 de Mauro, IZ2BKT
Reply
#4
I sent you a PM with the modified quickset.dat file. The problem is that you have stored the RF value to zero
73 de Mauro, IZ2BKT
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)