Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IC7100BKT and MyDDE2
#1
Hello

All weekend tried to figure out how to work with orbitron and IC7100
Installed mydde2 , and orbitron sends the rx and tx freq change (doppler) to the radio, but radio change every second from vfoA to vfoB (where vfoA is the RX and vfoB is the TX freq) - so can't use it at all...
My 857 radio and the orbitron program with wispdde , orbitron sends the rx and tx to radio ; on radio i'm on rx freq all the time , and it change to the tx freq only when i tx the radio.

73
Zoli
Reply
#2
Hi Zoli,
MyDDE is an old project that should be updated, however, go into MyDDE options and check Update only RX VFO
73 de Mauro, IZ2BKT
Reply
#3
Thanks Mauro

Tried right now, but if i check update only rx vfo, than the tx frequency isn't updated....only the rx
There is a possibility to have only tx updated ?

Regards
Zoli
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)