09-29-2017, 07:13 PM
I have BktTimeSync 1.8.2 installed. I run on a Dell Latitude E6400, P8600 dual core, 8 GB ram, Win 7 Ultimate 64-Bit.
I use BktTimeSync for proper time calibration for use with WSJT-X. Where I operate, I do not have internet, so I synchronize via my a COM port to a Garmin ETrexH.
The time sync works just fine. However, bkttimesync uses a lot of CPU. If I close bkttimesync through in the interface, it closes, however the bkittimesync process keeps running and I have to terminate the program via Task Manager.
Anyone else have this issue or know what I can do to not have the program use so much CPU?
Thank You.
Kevin
I use BktTimeSync for proper time calibration for use with WSJT-X. Where I operate, I do not have internet, so I synchronize via my a COM port to a Garmin ETrexH.
The time sync works just fine. However, bkttimesync uses a lot of CPU. If I close bkttimesync through in the interface, it closes, however the bkittimesync process keeps running and I have to terminate the program via Task Manager.
Anyone else have this issue or know what I can do to not have the program use so much CPU?
Thank You.
Kevin